CURE-AR ACRYLIC RESIN BASED CONCRETE CURING MATERIAL
Acrylic resin & water based liquid curing material to prevent water loss of surface by creating a film layer, after concrete, screed or surface hardener application (in 30 kg plastic bins)
TSE ISO CE
PRODUCT ADVANTAGES
- CURE-AR provides labor and time advantage, by it’s easy application feature.
- Increases the surface hardness and prevents dust formation.
- Protects surface against effects of external environment at low humidity, high evaporation and high airflow conditions.
- Reduces possibility of shrinkage formation by high curing.
APPLICATION AREAS
Applied by roller, brush or spraying tool on concrete application surfaces (field concretes, retaining walls, columns, joists, terrace roofs, etc.), on C-FLOORHARDENER floor hardener application surfaces, on G-GROUT-ST and G-GROUTRAPID grout-installation-repair mortar application surfaces.
PREPARING SURFACE
Applicaton surfaces should be clean, sound and free from dust. Adhesion barrier materials (oil, dirt, dust etc.) should be cleaned. There shouldn’t be any water ponds on surface.
| TS EN 1504-2 / 03.2005 Surface Protection Materials / Covering Applications Acrylic Based Curing Material | |
| Principle | 8,2 (C) |
| Reaction To Fire | Class E |
| Adhesion Strength By Pull-Off | ≥ 0,8 N/mm² (0,5)b Horizaontal without traffic load |
| Water Vapor Permeability | Class II |
| Unit Consumption | 0,25 kg/m2 (120 m2 / 30 kg bin) |
APPLICATION METHODS
CURE-AR is ready to use, should be shaken before use. If it will be applied with roler, it is poured into a clean and wide bucket. If it will be applied by spraying, it is poured into the spraying machine’s hopper. Appiled by on the concrete surface as a one thin layer as uniformly and evenly. There should not be cure ponds on surface.
For Concrete Applications: Cure application should be start when freshly poured concrete surface starts tarnishing (when free water disappears). For concrete application with molds, cure should be applied immediately after removal of molds. For C-FLOOR-HARDENER Applications: Cure application should be start when C-FLOOR-HARDENER applied concrete surface starts drying (no print when pressed on surface). For G-GROUT-ST & G-GROUT-RAPID Applications: Cure application should be start when surface starts tarnishing.
Ambient and surface temperature should be between +5 ̊C and +30 ̊ during the application.
Mortar should not be applied on frozen, melting or within 24 hours danger of frost surfaces.
If there are lumps in mortar because of mixing, lumps should be taken from mortar, lumped mortar shouldn’t be applied.
Surface should be protected from direct sunlight, extreme wind and rain during and after the application.
Water more than 3 liters or any other materials should not be added in it.
If application is not homogeneous, color difference may be seen on surface.